Peerless PLAV70-UNL-S Dokumentacja

Models: PLAV70-UNL, PLAV70-UNL-S, PLAV70-UNLP, PLAV70-UNLP-SInstallation and Assembly - Universal Articulating Swivel Double-Arm for 42" - 65&quo

10 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11Note: "X" dimensions should be equal.• Tighten screws so adapter brackets are fi rmly

11 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into

12 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11Mounting and Removing Flat Panel ScreenRefer to mount instruction sheet for attachment of adapt

13 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11Position of screen may be adjusted vertically up to .79" in each direction by doing the fo

14 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11© 2011 Peerless Industries, Inc. Peerless Industries, Inc. (“Peerless”) warrants to original en

2 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11Tools Needed for Assembly• stud fi nder ("edge to edge" stud fi nder is recommended)• d

3 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11BSome parts may appear slightly different than illustrated.ADEFGHCIJKLNOPTQMR SUVPLAV70-UNLPLAV7

4 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11AAPLAV70-UNL PLAV70-UNL-S PLAV70-UNLP PLAV70-UNLP-SDescription Qty Part # Part # Part # Part #A

5 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11Wall plate (A) can be mounted to two studs that are 16" apart. Use a stud fi nder to locate

6 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11Use wall plate (A), making sure that it is level, as a template to mark holes. The top mounting

7 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11To route cables through cord management channels:Slide one mesh sleeve (T) over each cable. Use

8 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11Insert and tape carriage bolt (I) into top hole of tilt-roll assembly (B). Attach tilt-roll asse

9 of 14ISSUED: 06-05-06 SHEET #: 202-9142-7 06-27-11Insert two M10 screws (F) into swivel box on arm assembly (C) as shown. Leave approx. 1/4"