Peerless PLA60-UNLP Instrukcja Obsługi Pobierz pdf (Strona 6)

6 of 41

ISSUED: 06-05-06 SHEET #: 202-9141-10 06-14-12

Use wall plate (A), making sure that it is level, as

a template to mark holes. The top mounting slots

should be located at your desired display center.

Use the masonry bit to drill 3/8" (10mm) dia. holes

to a minimum depth of 3" (76mm). Insert anchors

(W) in holes À ush with wall as shown (right). Place

wall plate (A) over anchors (W) and secure with

5/16 x 3" wood screws (O) and washers (P).

Installation to Solid Concrete or Cinder Block Wall

CUTAWAY VIEW

INCORRECT CORRECT

wall

plate

wall

plate

plaster/

dry wall

plaster/

dry wall

concrete

Drill holes and insert anchors (W).

Place plate (A) over anchors (W) and secure with screws (O).

Tighten all fasteners.

concrete

surface

• When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" (35mm) of actual

concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount

in a solid part of the block, generally 1" (25mm) minimum from the side of the block. Cinder block must meet ASTM

C-90 speci¿ cations. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a

hammer drill to avoid breaking out the back of the hole when entering a void or cavity.

• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.

• Make sure that the supporting surface will safely support the combined load of the equipment and all attached

hardware and components.

WARNING

• Tighten screws so that wall plate is ¿ rmly attached,

but do not overtighten. Overtightening can damage

screws, greatly reducing their holding power.

• Never tighten in excess of 80 in. • lb (9 N.M.).

• Always attach concrete expansion anchors directly

to load-bearing concrete.

• Never attach concrete expansion anchors to

concrete covered with plaster, drywall, or other

¿ nishing material. If mounting to concrete surfaces

covered with a ¿ nishing surface is unavoidable (not

evaluated by UL), the ¿ nishing surface must be

counterbored as shown below. Be sure concrete

anchors do not pull away from concrete when

tightening screws. If plaster/drywall is thicker than

5/8" (16mm), custom fasteners must be supplied by

installer (not evaluated by UL).

WARNING

1 2 3 4 5 6 7 8 9 10 11 ... 40 41

Komentarze do niniejszej Instrukcji

Brak uwag

Peerless PLA60-UNLP Instrukcja Obsługi Strona 6

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Uchwyty ścienne do płaskich paneli Peerless PLA60-UNLP