Peerless ST640P-S Instrukcja Obsługi Pobierz pdf (Strona 8)

8 of 38

ISSUED: 11-26-07 SHEET #: 202-9256-6 04-05-11

Begin with the shortest length screw, hand thread through washer and tilt bracket into display as shown below.

Screw must make at least three full turns into the mounting hole and ﬁ t snug into place. Do not over tighten. If

screw cannot make three full turns into the display, select a longer length screw from the bafﬂ ed fastener pack.

Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE: Spacers may not be used, depending upon the type of display.

Begin with longer length screw, hand thread through washer, tilt bracket and spacer in that order into display as

shown below. Screw must make at least three full turns into the mounting hole and ﬁ t snug into place. Do not

over tighten. If screw cannot make three full turns into the display, select a longer length screw from the bafﬂ ed

fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

For Flat Back Display

For Bump-out or Recessed Back Display

DISPLAY

WASHER

SCREW

TILT BRACKET

(BB or CC)

ﬁ g. 2.2

SPACER

TILT BRACKET

(BB or CC)

DISPLAY

ﬁ g. 2.1

WASHER

SCREW

2-1

2-2

If you have any questions, please call Peerless customer care at 1-800-865-2112.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Brak uwag

Peerless ST640P-S Instrukcja Obsługi Strona 8